Intel SRPL8 Manual do Utilizador descarregar pdf (Página 116)

116 Working Inside the System

Interchassis Management Bus (ICMB) Board

Removing the ICMB Board

See Figure 35.

1. Observe the safety precautions, warnings, and cautions at the beginning of this chapter.

2. Remove the top and 240 VA protective covers (see “Removing the Top Cover” on page 98).

3. Disconnect the ICMB signal cable from its connector on the I/O riser board.

4. Remove and save the screw that attaches the ICMB board to the I/O tray.

5. Push on the tabs of the snap-on standoff and pull the board toward the front of the chassis to

remove it from the snap-on standoff.

6. Place the board on a nonconductive, static-free surface, or store it in an antistatic protective

wrapper.

Installing the ICMB Board

See Figure 35.

1. Remove the ICMB board from its protective wrapper.

2. Position the board over the snap-on and threaded standoffs on the I/O tray.

3. Press the board onto the snap-on standoff, and insert the screw loosely into the threaded

standoffs.

4. Make sure the board is properly aligned, then tighten the screw firmly (8.0 inch-pounds).

5. Connect the signal cable to its connector on the I/O riser board.

6. Reinstall the top and 240 VA protective covers (see “Installing the Top Cover” on page 99).

OM07518

Figure 35. Removing the ICMB Board

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 227 228

Sem comentários

Intel SRPL8 Manual do Utilizador Página 116