Intel SR2520SAXNA Guia do Utilizador descarregar pdf (Página 125)

Intel

Server System SR2520SA User’s Guide 103

• Make sure you are using the correct and the current drivers. See “Server System

References” for a link to the current drivers.

• Make sure the driver is loaded and the protocols are bound.

• Make sure the hub port is configured for the same duplex mode as the network

controller.

• Make sure the correct networking software is installed.

• If you are directly connecting two servers (without a hub), you will need a crossover

cable.

• Check the network controller LEDs next to the NIC connectors.

Problems with Network

The server hangs when the drivers are loaded

• Certain drivers may require interrupts that are not shared with other PCI drivers. For

these drivers, it may be necessary to alter settings so that interrupts are not shared.

See the documentation that came with your PCI card(s) for information on changing

interrupts.

Diagnostics pass but the connection fails

• Make sure the network cable is securely attached.

• Make sure you specify the correct frame type in your NET.CFG file.

• The controller stopped working when an add-in adapter was installed.

• Make sure the cable is connected to the port from the onboard network controller.

• Make sure your BIOS is current. See “Server System References” for a link to the

current version.

• Make sure the other adapter supports shared interrupts. Make sure your operating

system supports shared interrupts.

• Try reseating the add-in adapter.

The add-in adapter stopped working without apparent cause

• Reseat the adater.

• Put the adapter in a different slot.

• The network driver files may be corrupt or deleted. Delete and then reinstall the

drivers.

• Run diagnostics.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 163 164

Sem comentários

Intel SR2520SAXNA Guia do Utilizador Página 125