Intel SERVER SYSTEM SR2500AL Manual do Utilizador descarregar pdf (Página 66)

44 Intel® Server System SR2500AL User’s Guide

Figure 33. Installing the Large Air Baffle

3. Install the server system cover. For instructions, see “Installing the Server System

Cover”.

4. Plug all peripheral devices and the AC power cable(s) into the server.

Installing and Removing a Hot-swap Hard Drive

Up to six hot-swap SAS or SATA drives can be installed.

Cautions: If you install less than six drives or devices, empty drive bays must be occupied by

carriers with baffles to maintain proper system cooling.

To avoid possible damage to your server system, do not use older style drive carriers.

Note: The server system does not support all hard drives. See “Server System References“ for

an Internet link to a list of supported hardware.

Installing a SAS or SATA Hot-swap Hard Disk Drive

1. Remove the front bezel if it is installed. For instructions, see “Removing the Front

Bezel”.

2. Open the latch at the front of the hard drive carrier. See letter "A" in the figure

below.

TP02134

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 209 210

Sem comentários

Intel SERVER SYSTEM SR2500AL Manual do Utilizador Página 66