Intel S5520SC Especificações descarregar pdf (Página 57)

Intel® Workstation Board S5520SC TPS Functional Architecture

Revision 1.7

Intel order number: E39530-010

Interface 1: This interface is available from either of the available NIC ports in system that can

be shared with the host. Only one NIC may be enabled for management traffic at any time. The

default active interface is onboard NIC1.

Interface 2:

This interface is available from Intel

Remote Management Module 3 (Intel

RMM3), which is a dedicated management NIC and not shared with the host.

For these channels, you can enable support for IPMI-over-LAN and DHCP.

For security reasons, embedded LAN channels have the following default settings:

 IP Address: Static

 All users disabled

You cannot place IPMI-enabled network interfaces on the same subnet. This includes the Intel

RMM3’s onboard network interface and either of the BMC’s embedded network interfaces.

3.8 Serial Ports

The workstation board provides two serial ports: an external RJ-45 serial port and an internal

DH-10 serial header.

The rear RJ-45 serial A port is a fully-functional serial port that can support any standard serial

device. To allow support for either of the two serial port configuration standards, you must

appropriately configure a jumper block (J4B2) according to the needed standard. For serial

devices that require a DCD signal, you must configure the jumper block with the serial port

jumper over pins 2 and 3. For serial devices that require a DSR signal (Default), you must

configure the jumper block with the serial port jumper over pins 1 and 2.

Note: By default, the rear RJ-45 serial port is configured to support a DSR signal.

Table 10. Serial A Port Configuration Jumper Pin-out

Pins What happens at system reset…

1-2 Rear RJ-45 Serial A port is configured for DSR to DTR (default)

3-4 Rear RJ-45 Serial A port is configured for DCD to DTR

For applications that require a DB9 serial connector, you must use an 8-pin RJ45-to-DB9

adapter (Accessory AXXRJ45DB92). The following table provides the pin-out required for the

adapter to provide RS232 support.

Table 11. Rear Serial A Port RJ-45 to DB9 Pin-out

RJ-45 Pins Signal Abbreviation DB9 pins

1 Request to Send RTS 7

2 Data Terminal Ready DTR 4

3 Transmitted Data TD 3

4 Signal Ground SGND 5

5 Ring Indicator RI 9

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 191 192

Sem comentários

Intel S5520SC Especificações Página 57